Phihong POE16S-1AFG Bedienungsanleitung

POE16S-1AFG User Manual

Power over Ethernet and Data Extender

Power over Ethernet has a range of about 100 meters

from the network switch. Should PoE be needed at

distances greater than 100 meters, solutions might

include electrical rewiring for AC power at a remote

location or moving network communications closets,

both require extensive labor and are costly and time

consuming. Phihong has developed a more cost

effective option with the POE16S-1AFG. Users can now

double the effective PoE Range of their devices to 200

meters while saving time and money.

By using your standard Category 5 or better Ethernet

cables the POE16S-1AFG takes its power from an

IEEE802.3at PoE Plus device (33.6W). The output

power is then dropped to be IEEE802.3af compatible

Its design is intended for use when expanding existing

networks. In the image seen above, the user wanted

to add an additional security camera 200 meters

from the network switch. The fi rst Ethernet cable not

exceeding 100 meters should be laid from the switch to

the POE16S-1AFG with a PoE Plus or better midspan

in between; another cable not exceeding 100 meters

should run from the extender to the security camera.

The POE16S-1AFG is designed to be plug-and-

play, therefore is no additional software or hardware

installation required. Upon powering up, the device will

work automatically by taking the necessary power from

the midspan and relaying it on to the PoE device.

Compatible IEEE802.3af devices include but are not

limited to Security Cameras, Sensors, and wireless

network and access controllers.

Installation Sequence:

1) Using the appropriate Ethernet cable, connect the

PoE In to the midspan inside the communications

cabinet.

2) Using an appropriate Ethernet cable, connect the

PoE Out to the given device, i.e. security camera

3) Wait a few seconds to allow connectivity before

reading the LED indicators.

PoE IN

Green LED 1: 10Mb activity

Green LED 2: 100Mb activity

Green LED 3: Gigabit activity

PoE OUT

Green LED 1: 10Mb activity

Green LED 2: 100Mb activity

Green LED 3: Gigabit activity

Ethernet

Green LED 1: Input power “ON”

Red LED: Fault detected

Green LED 2: Valid IEEE802.3af

load detected and connected

Should any connection fault occur the LEDs will blink

a code diagnosing the problem, for a complete listing

of those fault codes, please see the listing below under

troubleshooting. They are also listed on the data sheet

for this product on the individual product page on the

website, www.phihong.com.

Input Power

IEEE802.3at PoE Plus (30W) and

IEEE802.3af compatible (19W)*.

Input must be PoE.

Output Power

IEEE802.3af compliant 9W

Ethernet

Category 5 or better

Dimensions

120x60x32mm

(4.72x2.36x1.26in)

Weight

0.5kg

(1.1lb)

Operating

Temperature

0 to +55°C

32 to +131°F

Humidity

5 - 90%

*If IEEE802.3af is the input power source then the output

power is restricted to approximately 8W.

ADVANCING

POE TECHNOLOGY