Rotel RSP-1570 Bedienungsanleitung

Rotel RSP-1570
8.3 · 2
PDF Bedienungsanleitung
 · 50 Seiten
Englisch
BedienungsanleitungRotel RSP-1570
2 3

English

RSP-1570 Surround Sound Processor

2 3

English

RSP-1570 Surround Sound Processor

> 10 cm
> 4 in
> 10 cm
> 4 in
> 10 cm
> 4 in
> 10 cm > 4 in
Rotel products are designed to comply with international
directives on the Restriction of Hazardous Substances
(RoHS) in electrical and electronic equipment and the
disposal of Waste Electrical and Electronic Equipment
(WEEE). The crossed wheelie bin symbol indicates
compliance and that the products must be appropriately
recycled or processed in accordance with these directives.
This symbol means that this unit is double insulated. An
earth or ground connection is not required.

Notice

The COMPUTER I/O connection should be handled by authorized persons only.

FCC Information

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.(TV, radio, etc.)
Increase the separation between the equipment and receiver
Connect the equipment to an outlet on circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for additional help.

Caution

This device complies with part 15 of the FCC Rules. Operation is subject to the following to
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE TO CATV SYSTEM INSTALLER: Call the CATV system or antenna installer’s attention to
Article 820-40 of the NEC. This provides guidelines for proper grounding and, in particular, specifies
that the cable ground shall be connected to the grounding system of the building, as close to the
point of cable entry as practical. See installation diagram.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against interference in a residential installation. This equipment generates and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause interference to radio or TV communications. There is no guarantee that interference will
not occur in a particular installation. If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off and on, try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the unit and the television tuner.
Connect the unit to an AC power outlet on a different electrical circuit.
Consult your authorized Rotel retailer for assistance.

Important Safety Instructions

WARNING: There are no user serviceable parts inside. Refer all servicing to qualified service
personnel.
WARNING: To reduce the risk of fire or electric shock, do not expose the unit to moisture or water.
Do not expose the unit to dripping or splashing. Do not place objects filled with liquids, such as
vases, on the unit. Do not allow foreign objects to get into the enclosure. If the unit is exposed to
moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from
the wall. Take the unit to a qualified service person for inspection and necessary repairs.
Read all the instructions before connecting or operating the unit.
Keep this manual so you can refer to these safety instructions.
Heed all warnings and safety information in these instructions and on the product itself. Follow all
operating instructions.
Clean the enclosure only with a dry cloth or a vacuum cleaner.
Do not use this unit near water.
You must allow a minimum 10 cm or 4 inches of unobstructed clearance around the unit. Do not
place the unit on a bed, sofa, rug, or similar surface that could block the ventilation openings. If
the unit is placed in a bookcase or cabinet, there must be ventilation of the cabinet to allow proper
cooling.
Keep the component away from radiators, heat registers, stoves, or any other appliance that
produces heat.
The unit must be connected to a power supply only of the type and voltage specified on the rear
panel. (USA: 120 V/60Hz, EC: 230V/50Hz)
Connect the component to the power outlet only with the supplied power supply cable or an exact
equivalent. Do not modify the supplied cable. A polarized plug has two blades, with one wider than
the other. A grounding plug has two blades plus a third grounding prong. These are provided for
your safety. Do not defeat grounding and/or polarization safety provisions. If the supplied plug
does not fit your outlet, please consult an electrician for replacement of the obsolete outlet. Do not
use extension cords.
The main plug of the power cordset is a disconnect device of the apparatus. In order to completely
disconnect the apparatus from the supply mains, the main plug of the power cordset should be
unplugged from the mains (AC) outlet. The stand-by LED indicator will not be lit up to show the
power cord is unplugged. The disconnect device should remain readily operable.
Do not route the power cord where it will be crushed, pinched, bent, exposed to heat, or damaged in
any way. Pay particular attention to the power cord at the plug and where the cord exits the unit.
The power cord should be unplugged from the wall outlet during a lightning storm or if the unit is to
be left unused for a long period.
Use only accessories specified by the manufacturer.
Use only with a cart, stand, rack, bracket or shelf system recommended by Rotel. Use caution when
moving the unit in a stand or rack to avoid injury from a tip-over.
Immediately stop using the component and have it inspected and/or serviced by a qualified service
agency if:
The power supply cord or plug has been damaged.
Objects have fallen or liquid has been spilled into the unit.
The unit has been exposed to rain.
The unit shows signs of improper operation
The unit has been dropped or damaged in any way
WARNING: The master power switch is located on the rear panel. The unit must be located in the
open area allowing unobstructed access to the main power switch.
3U
RSP-1570
(RSP-1069)
RSP-1570 English v1.2.indd 2-3 7/10/08 00:03:39

Sehen Sie sich hier kostenlos das Handbuch für Rotel RSP-1570 an. Dieses Handbuch fällt unter die Kategorie Empfänger und wurde von 2 Personen mit einem Durchschnitt von 8.3 bewertet. Dieses Handbuch ist in den folgenden Sprachen verfügbar: Englisch. Haben Sie eine Frage zum Rotel RSP-1570 oder benötigen Sie Hilfe? Stellen Sie hier Ihre Frage

Brauchen Sie Hilfe?

Haben Sie eine Frage zum Rotel und die Antwort steht nicht im Handbuch? Stellen Sie hier Ihre Frage. Geben Sie eine klare und umfassende Beschreibung des Problems und Ihrer Frage an. Je besser Ihr Problem und Ihre Frage beschrieben sind, desto einfacher ist es für andere Rotel -Besitzer, Ihnen eine gute Antwort zu geben.

Werner Dahmen • 16-2-2022Keine Kommentare

Hallo zusammen, ich habe den Rotel RSP-1570.Dazu habe ich mir jetzt einen LG77 C19LA Tv gekauft. Wollte ihn wie meinen alten Panasonic über HDMI anschließen. Habe aber kein Bild und Ton. Habe alle Ausgänge vom TV getestet, auch eacr.Hat da jemand eine Idee oder Lösung?Gruß Werner

Diese Frage beantworten

Anzahl der Fragen: 1

Allgemeines
Rotel
RSP-1570 | RSP1570
Empfänger
Englisch
Benutzerhandbuch (PDF)
Audio
Audio Kanäle- Kanäle
Leistungshöhepunkt pro Kanal- W
Verstärkerklasse-
THD, totalklirren0.05 %
Rauschverhältnis (SNR)95 dB
Frequenzbereich10 - 100000000 Hz
Ausgabeebene0.001 mV
Eingang Empfindlichkeit200 mV
Synchronisations-Eingangsimpedanz100000 Ohm
Output Widerstand250 Ohm
Anschlüsse und Schnittstellen
Lautsprecher-Konnektivitätstyp-
Technische Details
ProduktfarbeSilber
ZweckHaus
ÜbertragungstechnikKabelgebunden
LautstärkereglerDrehregler
Bass-JustageJa
Treble JustageJa
Rack-Kapazität3U
Ein-/AusschalterJa
Bildschirm
Eingebautes DisplayJa
Leistung
AC Eingangsspannung120-230 V
AC Eingangsfrequenz50 - 60 Hz
Stromverbrauch (Standardbetrieb)60 W
Stromverbrauch (Standby)5.5 W
Gewicht und Abmessungen
Breite431 mm
Tiefe335 mm
Höhe144 mm
Gewicht9600 g
Anzeige
LED-AnzeigenJa
Lieferumfang
BenutzerhandbuchJa
BetriebsanleitungJa
Mehr anzeigen

Finden Sie die Antwort auf Ihre Frage nicht im Handbuch? Vielleicht finden Sie die Antwort auf Ihre Frage in den FAQs zu Rotel RSP-1570 unten.

Ist Ihre Frage nicht aufgeführt? Stellen Sie hier Ihre Frage

Keine Ergebnisse

Bedienungsanleitu.ng

© Copyright 2023 Bedienungsanleitu.ng. Alle Rechte vorbehalten.